Carton sealing machine is widely used in the field of carton packaging. The carton sealing machines are easy to operate and have a low failure rate. Here are some common failures and corresponding solutions.
Common problems and solutions of carton sealer
Q1:The tape cannot be cut
When the blade of the carton sealer is not sharp enough; the tape cannot be cut when the blade tip is blocked with glue, you can replace the blade, clean the blade to ensure that the tape can be cut.
Q2:There is trailing after the tape is cut
It may be that the blade is not sharp enough, or the tension spring is too loose, check whether the screws on the machine tool holder are too loose.
Q3:Tape does not fully adhere to the box
It may be that the main spring of the carton sealer is too loose; deposits are deposited on the roller shaft; the glue is not working properly; the tape is not qualified. The main spring can be tightened; the roller shaft can be smoothed; the tape can be replaced.
Q4:The box gets stuck in the middle
The belt wheel adjustment nut in carton sealing machine is too tight; the box height is not adjusted reasonably; the active spring is too tight, Tape wheel adjustment nut can be loosened; height readjusted; spring loosened.
Q5:Tape breaks during sealing
It may be that the blade sticks out too long; the tape is unqualified, you can lower the position of the blade; replace the tape.
Q6:Tape often derails
Because the pressure of the guide rollers on the box is uneven, the tape is often derailed, and the distance between the guide rollers can be readjusted
Q7:Motor does not turn
Possibly because the power thermal relay has tripped; the motor is damaged; the chain is not normal; the motor shaft is not normal; the screw is loose.Check whether the thermal relay at the power switch has tripped and the power has been disconnected; you can check whether the motor is damaged; check whether the chain is normal; check whether the motor shaft is normal; check whether the screws are loose.
Maintenance of carton sealer
1. Regularly replace the lubricating oil in the worm gear reducer of the sealing machine. The lubricating oil can be selected from No. 10, No. 20 or No. 30 oil.
2. If the chain is loose during use, it can be adjusted by removing a few sections first. If the chain is seriously too long, you need to contact the after-sales service personnel for professional maintenance.
3. After the repair of the carton sealing machine is completed, re-run it again to observe whether the machine works normally, heat the drum properly, and must not be impatient.
4. Regularly disassemble and clean all rolling bearings of the carton sealing machine, and add new grease.
5. Regularly remove the dirt on all friction surfaces, regularly clean the chain and sprocket, and refill the lubricating oil.
6. Remember to disconnect the power supply during maintenance and maintenance to avoid dangerous situations.
Tom’s carton sealing machine has stable performance, reliable quality, high sealing efficiency, wide range, fast speed and long service life. The case sealing machine is a highly automated case sealing machine. It can be used alone or in combination with an automated packaging line. It is a high-quality choice for enterprises to save costs, improve production efficiency and achieve packaging standardization.
